Lexus IS Forum banner


2636 Views 46 Replies 11 Participants Last post by  BLACK_IS 300
Just wanted to let you san diego locals know about my great conversation with Kearny Mesa Lexus: called and spoke with a service technician about scheduling my 10,000 mile oil change and when I asked about the trac/ecu update, they knew exactly what I was talking about! The technician ordered the part today and I will have the update installed next week when the new trac unit comes in. The tech said that they are going to replace the whole trac unit and also reprogram the ecu. Can't wait. Will keep you guys informed about any improvements in the hesitation. So for all you san diego guys, call kearny mesa lexus and they'll hook you up with the updates!

1 - 4 of 47 Posts
Black_is300 & mkaufman,
Count me in. I wouldn't mind coming over to Lexus Kearny Mesa when Black goes in for his ECU/TRAC upgrade. I'd like to see what they do to do the upgrade. I work at Sorrento Valley, so I can get to Kearny Mesa really quick (unless of course I get stuck at work). Just let me know.

Black_IS 300,
Right now I'm pretty much sitting back and watching the results of the upgrades. I'm a little bit paranoid at this point especially since I've only experienced about 5 incidents of hesitation with my IS. They have been only slight hesitations, but I don't know if they will eventually get worse. If the upgrades show improvements with no or little side effects, then I'll get the upgrades.

Meeting san diego people WOULD be cool, no doubt.

Cool! I'm glad the results were great. Now who's next to go Lexus Carlsbad?

No wonder my IS came back with a full tank of gas after getting my 10K service at Kearny Mesa this past Saturday! During this service they said they were going to replace the undercarriage panel, but I didn't know they were going to fill my tank. Damn, I should have brought it in empty rather than half tank. Oh well ...

1 - 4 of 47 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.