Thanks.
1 - 3 of 3 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Aftermarket oil pans any good?
General DiscussionAnyone have any experience with an aftermarket OE replacement oil pan? Mine is dented from the PO and since I have to pull it to address the gasket leak i was going to replace it. The aftermarket ones are WAY cheaper than OE. But I am curious about the manufacture quality. Doesn't seem like...- 6
- 154
-
C1ph3r · updated
-
Sub frame geometry...?
General DiscussionLong story short i hopped a curb going about 45 degrees into it at maybe about 20 mph passenger tire first.... i put all new lower control arms on it. I got everythin to bolt up pretty nicely except the drivers side i had to basicly force the camber adjustment bolt into place, So it sits ever...- 1
- 52
-
I want to modify my car.... but my miles are high...
General DiscussionHey guys and gals, I was wondering if it would worth my time and money to invest in my 2004 is 300? Nothing too crazy, just add some better rims, better brake kit (slotted, drilled, or blank?), maybe lowering springs, and possibly an exhaust. now i know most of this maybe a must while others...- 20
- 369
-
Questions about R154 swap with 1JZGTE
General DiscussionOk guys I just got the work I wanted done for my 1JZGTE swapped IS300 with a w55. I haven't gotten it tuned just yet but I have about $2,000 left on my budget. Not quiet enough I know but I am close. I'm probably going to be pushing 400hp which I know can be dangerous for the current...- 4
- 219
-
IS200 J160 gearbox issue
General DiscussionHi guys, Hope you're all well! Please bare with me as this is my first forum post! I'm having an issue with my gearbox and wondering if someone could help. After about 40 mins of normal driving gear changes become difficult sometimes so difficult i can't even get into first or reverse...- 23
- 694
Join now to ask and comment!