Lexus IS Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,085 Posts
Discussion Starter #1
I'm thinking of running a Lanzar VIBE 1200D amp to drive my 2 Audiobahn ALUM10 subs but was wondering how to turn the amp on remotely since the IS doesn't have a power antenna. For those who have run an amp/sub combo, how did you wire the amp to power up when the radio is on?

Thanks...

Mark
 

·
Registered
Joined
·
253 Posts
Originally posted by MrMark:
I'm thinking of running a Lanzar VIBE 1200D amp to drive my 2 Audiobahn ALUM10 subs but was wondering how to turn the amp on remotely since the IS doesn't have a power antenna. For those who have run an amp/sub combo, how did you wire the amp to power up when the radio is on?

Thanks...

Mark
I wired the remote turn on wire from the amp to the ignition wire which you can find in the fuse box located in the kick panel on the passenger side. Just look at the diagram on the back side of the panel to find the igniton fuse. I did this so the amp will only be on when the car is running, that way I wont kill my battery which I used to always do with my other cars. Hope this helps.


[This message has been edited by nutinbut (edited December 05, 2000).]
 
1 - 4 of 4 Posts
Top