[Engis300]

i have the standard 60-1 hi-fi turbo that coems with this kit and im just wondering how much bigger of a compressor housing can fit down there since its a bottom mount turbo and all... and the crossmember seems to be an issue already when installing...not after install theres plenty of clerance..just wondering if anyone out there has tried it already

 

[300iss]

Didnt you already part out your turbo kit?

...but to answer your question, redline had a t72 on a cast mani on his old setup.

 

[redline814]

300iss is correct. It had a GTQ housing. I made 515rwhp on 93 pump gas (with many supporting mods).

It made great low end power...vs the tubular one I later switched to.

You will have to move the brake lines a bit to make it fit.

 

[Engis300]

ohh ok gotcha..well i am aprting out the kit but nothing is biting at the moment

so i figured it would be ebettr on the car than sitting takign up space.

thanks for that i was going to get a 67mm compressor wheel upgrade which eneds the bigger housing since i have the Hi-FI 60-1

i wasnt sure if it could squeze down there or not tho...

but if brake lines are my only problem then i dont think ill be too worried