Lexus IS Forum banner
1 - 18 of 18 Posts

· Registered
Joined
·
3,220 Posts
Discussion Starter · #1 ·
I just got a new Canon S100 Digital camera, so I stepped outside and took a few pictures:



Note the CCM speakerphone/charger for my Nokia phone, and the "normally closed" replacement traction control on/off switch.



The new heated mirror switch...



I like bare black pedals better than aluminum cover plates.



Gee - what is that in there? Do you have one???
 

· Registered
Joined
·
35 Posts
Well... at least the picture quality is good...


------------------
TONY... YOU KNOW WHAT I WANT TO SAY... RIGHT?


[From TEG: What are you trying to say?
Do you think my mods are tacky??? ]


[This message has been edited by TEG (edited November 10, 2000).]
 

· Registered
Joined
·
80 Posts
TEG - the heated mirror switch.. that looks just like the fog light switch on my past '98 Camry. The fog lights on that Camry was port installed, and insted of a switch on the light switch stalk, it had a separate switch on the lower left part of the dash.
 

· Registered
Joined
·
214 Posts
TEG- you set the volumes where i set mine at
with your new sub, how do you like it there??

sometimes i go louder, cause i have two and can't barely hear those HIGHS and MIDS..
you know what i mean..


------------------
xxsiLveR_iS300xx
 

· Registered
Joined
·
6,512 Posts
TEG, very creative of you! That's good stuff. What about replacing the pedals with real_drilled_aluminum pedals?
 

· Registered
Joined
·
613 Posts
TEG- does your subwoofer make anything in your car rattle after awhile? I know in all the other cars i've owned i put in like 2 12' subs and after awhile the car would sqeak everytime the bass hit. I don't want my IS to be like that

------------------
Yellow IS/ 90 Honda Crx (Hybrid)

[From TEG: NO! I hate it when there is buzzing or rattling. I mounted everything with foam tape between the woofer, the mounting board, etc, etc. No rattles even at full volume!]



[This message has been edited by TEG (edited November 10, 2000).]
 

· Registered
Joined
·
34 Posts
Hey TEG u might want to vacuum next time before u start taking pics.


------------------
00 SE ALTIMA W/LTHR, 5SPD
CAI INTAKE and STUFF
18" GIOVANNA BARLETTA W/225/35

[From TEG: LOL! Yeah - I was too excited about the new digital camera to wait until the car got cleaned up again. Sorry. ]


[This message has been edited by TEG (edited November 10, 2000).]
 

· Registered
Joined
·
3,267 Posts
TEG,

You are quite the handy-man. Quick question. Aren't your bald pedals more slippery when they are wet? Isn't that somewhat unsafe?

-crontab -l

------------------
An Ecstatic Owner of a Fully-Loaded Graphite Gray 2001 Lexus IS 300

[From TEG: I suppose, but I have found that rubber soled shoes stick to pedals just fine. No problems that I have noticed. ]


[This message has been edited by TEG (edited November 10, 2000).]
 

· Podiatrist
Joined
·
22,491 Posts
Teg, you gotta tell me how you made that fan and whether it works. I also posted in the interior/exterior mods section.

What i'm worried about is at high speeds, the fan will restrict airflow into the filter.

It looks like you took a computer cooling fan, rounded the edges and stuck in a RC car motor. That's what I'd do if I tried it.

Mind telling us? I'd really like to know...
Does it sound better?

[From TEG: Read the eRAM FAQ ]


[This message has been edited by TEG (edited November 10, 2000).]
 

· Registered
Joined
·
3,247 Posts
how much did the camera cost you TEG?
I am thinking about buying one too

[From TEG: S100 "Holiday Pack" from Camera world of Oregon. $499 including an extra 32MB CF card, and a carrying case. ]



[This message has been edited by TEG (edited November 10, 2000).]
 
1 - 18 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top