Lexus IS Forum banner

1 - 20 of 34 Posts

·
Registered
Joined
·
1,444 Posts
I like it. I might have to pick one up for myself.
 

·
Latex salesman
Joined
·
5,633 Posts
Discussion Starter #3
Ask for Jon. It was $89 shipped.
 

·
Dr. JDM
Joined
·
9,332 Posts
pics installed please
 

·
Registered
Joined
·
1,600 Posts
Had this on my Toyota Celica. Just didn't like the fact that it wasn't real CF. Anything other then stock is always a plus of course!
 

·
Latex salesman
Joined
·
5,633 Posts
Discussion Starter #11

·
Latex salesman
Joined
·
5,633 Posts
Discussion Starter #14 (Edited)
It just slips over your existing handle and you tighten it with the supplied screws and allen wrench. It's a universal handbrake cover.
 
  • Like
Reactions: Chigger

·
Registered
Joined
·
157 Posts
is it wider than the stock one? I bought a leather momo knob for my car and it matched the stock e brake really well so I left it alone
 

·
Latex salesman
Joined
·
5,633 Posts
Discussion Starter #17
I haven't done it yet because my car is in the shop. Just look at the above post from destron25. Mine should be no different.
 

·
Registered
Joined
·
1,600 Posts
So is this placed over the existing handle or do we have to remove the old handle? Hard to tell from the pic.
 

·
Latex salesman
Joined
·
5,633 Posts
Discussion Starter #19
Yes, it goes over your existing handle. I guess you could really call it a handbrake cover.
 
  • Like
Reactions: somguy2u

·
Registered
Joined
·
194 Posts
Hey, i just got a Momo shift knob for my 5spd, will fit on there but i cant get the shift boot to go down far enough so that i could have the room slide the bottem ring down in order to put in the 3 little screws to secure it, any ideas how i could get that room?
 
1 - 20 of 34 Posts
Top