Lexus IS Forum banner

1 - 20 of 140 Posts

·
Registered
Joined
·
199 Posts
Discussion Starter #1
Hello everyone. I am from Athens-Greece and I have a Lexus IS200 which I have fitted a bolt-on Supercharger. I am a member of the club for a whlie. Here are the mods that i have done up to know and I am continuing the upgrades :D

Lexus IS200 Granite Sky / 2001 Model


Engine:

TTE Supercharger (Eaton M62)

K&N Air Filter

Upgraded Stage 1 Supercharger Pulley

C-One Radiator Cooling Panel

DKNE EXT121 Exhaust Manifold

HJS 200 Cell Katalytic Converter

HKS Silent Hi Power Muffler

Greddy Emanage Ultimate Ecu

Greddy 3Bar Map Sensor

Denso 310cc injectors

Snow Performance Water / Methanol Stage 2 Kit

King Slender Intercooler

Denso IK22 Iridium Spark Plugs

Earth Kit

SFS Silicone Hoses Red Compressor

SFS Red Radiator Silicone Hoses

HKS D1 Oil Cap

Tom's Radiator Cap

Mocal Oil Cooler Kit

C-One Underbody Panel

Drive Terrain

TRD Pressure Clutch & Plate

Comrade C's Short Stroke Shift

Torsen LSD from Sport Version

Suspension, Chassis & Brakes:

Front Strut Bar

Tanabe Rear Strut Bar

K-Sport Coilovers

Hotchkis Sway Bars

Ultra Racing Rear Lower Bars

Four Point Tanabe Front Under Brace

Four Point Tanabe Rear Under Brace

Cusco Trunk Bar

Cusco Type I bar

Front EBC Grooved-Drilled Brake Discs

EBC Green Pads

Goodridge Brake Lines


Exterior:

TTE Front Bumper

TTE Boot Spoiler

JDM Antenna

TTE Chicane 17x 7.5 ET35 "Rims

L-Sportline Roof Spoiler

Ganador Mirrors

Interior:

AEM Boost Pressure Gauge

AEM Uego Gauge

PLX D-5 EGT Gauge

TRD Leather Gear Knob

Custom TRD Style Gauge Pod

Black Door Armrest

TTE Compressor Stainless Steel Dials

3M Carbon Vinyl Door Switches

Rod-Millen Floor Mats












































 

·
Registered
Joined
·
199 Posts
Discussion Starter #4
The Greddy Ultimate ecu and 2.5m harness i bought to upgrade my car.





Greddy 3bar map sensor and wire extension





Denso 310cc injectors






The Denso 310cc injectors are going to be fitted tomorrow together with the bigger pulley and new supercharger

Denso service repair kit

 

·
Registered
Joined
·
199 Posts
Discussion Starter #5
Greddy ecu harness wiring with OEM ecu







3bar map sensor



Greddy ultimate ecu in the car and under the carpet at passenger side (not very good pics though)



 

·
Registered
Joined
·
199 Posts
Discussion Starter #7
Here is the dyno chart:



6.5 psi at 4000rpm and 6.8 psi at rev limit. Max wheel hp 205, 245bhp :clap: :clap:

Here is also one of the videos i took during mapping of the car:


One more video:


and 32kg of torque!!!!
 

·
Registered
Joined
·
199 Posts
Discussion Starter #9
Rod Millen Floor Mats:



C-One Underbody Aluminium Panel





A few pics of the floor mats in the car. The underbody panel will be fitted soon.



 

·
Registered
Joined
·
199 Posts
Discussion Starter #10
Here are some pics of my new TRD pressure clutch-plate. I am waiting for the lightweight Jun flywheel to arrive in order to fit both on the car.





 

·
Registered
Joined
·
1,724 Posts
go0d stuff; nice upgrades
 

·
Registered
Joined
·
528 Posts
Nice looking car. Looks like it's got all the good stuff on it now. I was surprised how nice the cars were in Athens when I was there. Even the taxi cabs were nicer than my car. (and man the girls are top notch too!)
 

·
Registered
Joined
·
199 Posts
Discussion Starter #20
Valhallab thank you for the comments and i am pleased you had a pleasant time in Greece.

Venticello it took almost two years to bring the car up to this state. It is hard in Europe to find all these aftermarket parts. I hope one day your ride will look like mine.
 
1 - 20 of 140 Posts
Top