Lexus IS Forum banner
1 - 1 of 2 Posts

·
Registered
Joined
·
102 Posts
Sorry to bring up an old thread, but i think i have a valid question..

I will be installing halos, and want to delete my DRLs, and have my halos be DRL. Could I just unplug the DRLs from the resistor, and wire the halos into that, or will that cause problems with the high beams? The main reason I want to do this, is so my halos can work on the factory light switch next to the steering wheel. If this isn't the best way to do this, what would be better?

Or what if I unplugged the wiring from the little resistor box, and wired my halos into that wire? Would that make them run off the light switch next to my steering wheel? Or would there be a problem with the high beams, or too much current going to the halos. If you don't think I should do it this way, what would you suggest as a better way to do it? My main concern is to have the halos be on the stock switch, making them look as OEM as possible.

Thanks in advance,
 
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top