Lexus IS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
45 Posts
I have a question... I have a toyota land cruiser master cylinder and a GM slave cylinder. How do I connect them? This is my first project and I'm very lost.
 

·
Registered
Joined
·
45 Posts
Getting ready to order all my parts from driftmotion. How important is it to measure the driveshaft when everything is all mocked up? Any potential issues with just going with Curran's recommended 51" measurement?
Very, I completed the swap a few months ago. I ordered mine at 50.25 and was very snug fit I get vibration on DCel also make sure you modify your transmission tunnel if you're going A to M. Another Also Is save yourself the trouble and go R154 route with the fork engagement it will save you time money and head aches.
 

·
Registered
Joined
·
45 Posts
Unfortunately I haven't figured it out complety, I still have vibration on deceleration extremely apparent over 80mph. I bought the driftmotion one that connects to cross member.
 
1 - 4 of 4 Posts
Top