Yea I need those specs too. PM me if you dont want to post it up.
Anyone Have Factory Specs for Toe and Camber Settings?
Right now my front wheels are Toe-in: +0.25 on both sides, Camber: 0
Rear Wheels: Toe: 0, Camber: -1.38 on both sides.
I feel that there is way too much negative Camber on my rear wheels. Does anyone have the specs? Do not want to pay dealer $160 for four wheel alignment and other folks do not have specs for '01 IS300 yet.
Side note, did not know our cars had it until vehicle was on a lift, however we have adjustments for Camber!!!
No Camber kits necessary! Thanks Everyone.
N1
Rear Wheels: Toe: 0, Camber: -1.38 on both sides.
I feel that there is way too much negative Camber on my rear wheels. Does anyone have the specs? Do not want to pay dealer $160 for four wheel alignment and other folks do not have specs for '01 IS300 yet.
Side note, did not know our cars had it until vehicle was on a lift, however we have adjustments for Camber!!!
No Camber kits necessary! Thanks Everyone.
N1
1 - 1 of 9 Posts
1 - 1 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Lexus IS Forum
Community dedicated to Lexus IS Enthusiasts. Come in and enjoy our articles, galleries and information on aftermarket parts for the IS300, IS250, IS350.
Full Forum Listing
Explore Our Forums
Top Contributors this Month
View All
ill_mannered
111 Replies
Jonqdiesel
50 Replies
Hodgdon Extreme
50 Replies
Recommended Communities
