[rude_boyja]

As the title states....would love someones input and/or MAP for AEM Infinity.

Got an built engine with a NON - VVTI head (1 cam tooth) and a 2jzgte bottom (36 -2 crank tooth) setup. I am using the generic 36-2 crank and 1 cam tooth option in the Infinity and I am getting STAT SYNC. It only gives me one crank over though...the car does not stay on...neither with pressing the accelerator or anything.

I do think my cam sync Adj and Trigger offset numbers are wrong.

Was just wondering if anyone else was running this setup and could shed some light/info to assist

TIA

 

[01 SolarYellow]

You could use a hall effect sensor on the the cam gear.

 

[ill_mannered]

Are your noise settings around 10?

 

[rude_boyja]

Are your noise settings around 10?

Noise for the crank : 10, noise for the cam: 70

 

[ill_mannered]

Noise for the crank : 10, noise for the cam: 70

You should try using 10/10 for both and adjust from there and see how it reacts. 70 seems a bit high.

 

[rude_boyja]

You should try using 10/10 for both and adjust from there and see how it reacts. 70 seems a bit high.

Tried that too...not much of a difference unfortunately