IS350 Audio/security/remote start, etc wiring info!!
Here is some info on the New IS350. Just thought I would pass along..
12V+ is green at Radio Harness
Acc is Orange at Radio Harness
Ground is White/Black at Radio Harness
Illumination is Green(+) at Radio Harness
Power antenna is Yellow(+) at radio harness
LF speaker (+)Light Blue
LF speaker (-) Orange
RF (+) Black
LR (+)Light Green
RR (+) Light Blue
RR (-) Red
-Headlights low beam is Red/White(-) at pass fuse panel gray 10 pin plug.
-Hazards is Lightblue(-) at switch or Yellow(-) at pass BECU(24 pin plug)
- Wipers low is Yellow(+) at driver BECU 26 pin plug
- Wipers high is Reb/Blue(+) at driver BECU 26 pin plug
- Parking Brake is Yellow/Black(-) at switch
- Trunk release is Pink(-) at switch or Passenger BECU 28 pin plug
-Fuel door release is Blue(+) at switch
-Seat memory 1 is Lightgreen(-) at switch in door
-Seat memory 2 is Red(-) at switch in door
-Horn is White(-) at steering column
-Reverse lights are Yellow(+) at driver fuse in 30 pin gray plug
-Brake lights are Red/Black(+) at brake switch
-Low current parking lights are Yellow(-) driver fuse 28 pin plug
-Speed sense is Blue(AC) at amp is passenger side of trunk
-Tach is White(AC) at data link connector
-Power lock is Blue(-) at switch in door
-Power unlock is White(-) at switch in door
(An extended pulse will roll windows up or down! A module is available already to interface this!)
Please note that Power source controller(PSC) is located behind the Glove box!!
Battery is Orange(+) at PSC 40 pin plug
Ignition 1 is Light Green(+) at PSC 40 pin plug
Ignition 2 is Pink(+) ate PSC in 40 pin plug
Acc1 is Light green(+) at PSC is a 40 pin plug
Starter1 is Light Blue(+) at PSC 40 pin plug
Starter 2 is Violet(+) at PSC 40 pin plug
All door trigger is Violet or Pink(-) at driver BECU 10 pin plug
Trunk trigger is Blue or Green(-) at Pass BECU 28 pin plug
Hood trigger is White/Blue(-) at switch must diode isolate
Alarm arm is done with door locks
Alarm disarm is done with door locks or Ignition and transponder!
Lisnup65 makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Lisnup65 disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
"Man is a rational animal who always loses his temper when called upon to act in accordance with the dictates of reason."